Assembly Instructions

1. Unfold the table topper and lay on a flat surface, printed side down.

2. Pre-fold the two longer sides of the table topper along the perforated crease. Note: It will not stay folded at this time.

3. Orient the topper so that one of the two shorter sides is in front of you.

4. Using one hand on the right side and one hand on the left side of the topper, fold the long sides upwards, and at the same time, use your thumbs to fold the small flaps (attached to long side) towards the center of the table topper, making a 90-degree angle.

5. Holding the small flaps in place with your pointer and middle fingers, use your thumbs to fold shorter side (with three locking tabs) over the small flaps. The locking tabs will fit into the corresponding holes in the bottom

6. Repeat the process on the other side

7. Enjoy!